Unable to read controller information

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

   Hi,

I am trying to build my own system under the system builder with FC machining application. However, whenever i tried to open the machining powerpac there is this System1 error message.

System1: Unable to read all controller information
Some function may not work correctly.

As a result, I am not able to choose the FC processes under in the solution wizard. 

I had tried to do the same steps with other computer and I did not face this problem at all. 

I am suspecting it is the software problem so i had reinstall all softwares, including Robotware, Robotstudio 5.11.02 and Power Pacs machining but still encounter the same problem with this computer.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
xXEricXx Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 2009-March-03 Location: SG Online Status: Offline Posts: 3	Quote Reply Topic: Unable to read controller information Posted: 2009-March-30 at 08:03
	Hi, I am trying to build my own system under the system builder with FC machining application. However, whenever i tried to open the machining powerpac there is this System1 error message. System1: Unable to read all controller information Some function may not work correctly. As a result, I am not able to choose the FC processes under in the solution wizard. I had tried to do the same steps with other computer and I did not face this problem at all. I am suspecting it is the software problem so i had reinstall all softwares, including Robotware, Robotstudio 5.11.02 and Power Pacs machining but still encounter the same problem with this computer.
	Eric Chia

xXEricXx Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 2009-March-03 Location: SG Online Status: Offline Posts: 3	Quote Reply Posted: 2009-April-01 at 03:45
	Hi, Is there any solution to fix this problem?
	Eric Chia

Neil Zhu Members Profile Send Private Message Find Members Posts Add to Buddy List Trainers & Pickmaster & Service Joined: 2008-June-30 Online Status: Offline Posts: 18	Quote Reply Posted: 2009-April-01 at 08:54
	Try to warmstart your VC and then start Machining PowerPac. /Neil

JBarbosa Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 2010-May-12 Online Status: Offline Posts: 1	Quote Reply Posted: 2010-May-12 at 22:44
	Hi, i also have this problem. First i thought it was because i was using RobotStudio 5.12.03 on Windows 7 64bits. Then i installed 5.13 version with the Patch and the problem still exists. Do you have any solution to this problem? regards Barbosa